Prepper Forum / Survivalist Forum banner
1 - 1 of 30 Posts

· Registered
240 Posts
I would use a router with a bit that cuts the bottom and sides at the same time with a bushing collar. Maybe start with a plywood jig with about a 2 inch hole in it to start and then enlarge the hole in the plywood jig after each pass. Pretty cool ashtray.I think that would be easier than trying to mount such a large piece in a lathe. That would work though.
1 - 1 of 30 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.